Free LPI LPIC-2 - Exam 201 (part 1 of 2), version 4.5 201-450 Exam Questions

Which of the filter keywords below could be used in the following command:

tcpdump --i eth0 ____________ 203.0.113.8 (Choose three.)

Considering the following kernel IP routing table below, which of the following commands must be used to remove the route to the network 10.10.1.0/24? (Select TWO answers)

Kernel IP routing table

Destination Gateway Genmask Flags Metric Ref Use Iface

203.0.113.162 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0

172.16.87.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0

192.168.246.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1

10.10.1.0 192.168.246.11 255.255.255.0 UG 0 0 0 eth1

127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo

0.0.0.0 203.0.113.162 0.0.0.0 UG 0 0 0 ppp0

Which sub command to crypsetup shows information about an encrypted LUKS partition?

Which is the main configuration file for the SystemV init process? (Specify the full name of the file, including path.)

Which of the following files will be looked for and used by GNU make, if one of them exists, unless a different file is specified on the command line when trying to compile software from source code? (Choose TWO correct answers.)

Which option to the update-rc.d command will cause the removal of all symlinks to /etc/rcX.d/*test2 even when the script /etc/init.d/test2 still exists?

What component of a system does smartd monitor?

What are the options to node.startup in the iscsid.conf file? (Choose TWO correct answers.)

What is incorrect about these entries in /etc/hosts which could be causing host name lookup problems with host2?

host1 192.168.1.12

host2 192.168.1.12

Which command can be used to scan a specified network looking for IP addresses that appear to be in use?

Which command is used to install a GRUB boot loader into the master boot record?

Which of the following filter keywords for tcpdump specify the transfer direction for network packets? (Choose TWO correct answers.)

In the following output, what is the 5 minute load average for the system?

# uptime

12:10:05 up 18 days, 19:00, 2 users, load average: 0.47, 24.71, 35.31

What is the correct parameter to pass to the kernel at boot time to force it to use only one of the available processors?

The following is an excerpt from the output of tcpdump -nli eth1:

13:03:17.277327 IP 192.168.123.5.1065 > 192.168.5.112.21: Flags [.], ack 1 (truncated)

13:03:17.598624 IP 192.168.5.112.21 > 192.168.123.5.1065: Flags [P.], seq (truncated)

Which network service or protocol was used?