Scenario: Users are attempting to logon through Citrix Gateway. They successfully pass the Endpoint Analysis (EPA) scan, but are NOT able to see the client choices at logon.
What can a Citrix Administrator disable to allow users to see the client choices at logon?
Scenario: A Citrix Administrator configured the policies below:
POLICY 1:
add rewrite action ACT_1 corrupt_http_header Accept-Encoding
add rewrite policy POL_1 HTTP.REQ.IS_VALID ACT_1
POLICY 2:
add rewrite action ACT_2 insert_http_header Accept-Encoding ''\''identity\''''
add rewrite policy POL_2 ''HTTP.REQ.IS_VALID'' ACT_2
Which set of commands can the administrator use to bind the rewrite policies to the LB vserver lb_vsrv so that
POL_2 is evaluated after POL_1 is evaluated successfully?
Scenario: A Citrix Administrator is configuring a new authentication, authorization, and auditing (AAA) virtual
server, and the status is DOWN. The administrator makes the below configurations:
add lb vserver lb_vsrv_www HTTP 10.107.149.229 80 -persistenceType NONE -cltTimeout 180 -authn401 ON
-authnVsName SAML_SP
bind lb vserver lb_vsrv_www_ssl Red_srv
bind lb vserver Ib_vsrv_www_ssl Blue_srv
add authentication vserver SAML_SP SSL 10.107.149.230 443 -AuthenticationDomain citrix.lab
What should the administrator bind to the virtual server SAML_SP to complete the installation and change the
status to UP?
Scenario: A Junior Citrix Administrator needs to create a content switching virtual server on a Citrix ADC high availability (HA) pair. The NSIP addresses are 192 168.20.10 and 192.168.20.11. The junior administrator connects to NSIP address 192.168.20.10 and saves the changes.
The following day, a Senior Citrix Administrator tests the new content switching virtual server, but it is NOT working. The senior administrator connects to the HA pair and discovers that everything the junior administrator configured is NOT visible.
Why has the Citrix ADC lost the newly added configurations?
Scenario: A Citrix Administrator configures an access control list (ACL) to block traffic from the IP address 10.102.29.5:
add simpleacl rule1 DENY -srcIP 10.102.29.5
A week later, the administrator discovers that the ACL is no longer present on the Citrix ADC.
What could be the reason for this?
Scenario: A Citrix Administrator suspects an attack on a load-balancing virtual server (IP address
192.168.100.25). The administrator needs to restrict access to this virtual server for 10 minutes.
Which access control list (ACL) will accomplish this?
While applying a new Citrix ADC device, a Citrix Administrator notices an issue with the time on the appliance.
Which two steps can the administrator perform to automatically adjust the time? (Choose two.)
Scenario: A Citrix Administrator manages an environment that has three SSL websites, all serving the same content.
The administrator would like to consolidate the websites into a single, load-balanced SSL virtual server.
What can the administrator bind to use a single SSL virtual server?
What is a recommended practice for managing a Citrix ADC high availability (HA) pair to ensure that management changes are always made on the primary Citrix ADC?
Which Citrix ADC service monitor can a Citrix Administrator use to test the three-way handshake between the Citrix ADC and the backend server?
